Extend the bolt using the inside thumbturn.Extend and retract the bolt using the inside thumbturn.Wait until the bolt stops moving before continuing.With door open, enter one of the default user codes.You must perform setup procedure before using your lock. You're not finished yet! You must perform the set up procedure in the next step for the lock to work! Reinstall the battery pack and battery cover.Remove the battery holder and insert batteries.We don't recommend them because they don't give you a lot of time to change your batteries before the lock is completely dead. Lithium batteries may have a longer life, but when they begin to fail, they fail quickly. Use four high-quality alkaline AA batteries for replacement.This will ensure continued reliable operation. Replace the batteries in your lock at the same time each year that you test and replace the batteries in your smoke alarms.Secure the inside assembly with screws.Press inside assembly onto the mounting plate.If it does not line up, make sure the thumbturn is vertical. The bump on the tailpiece aligns with the slot in the back of the inside assembly. Connect cable from outside touchscreen to the connector on the inside assembly.The HomeKit sticker is located on the front of the inside assembly and on the back of the printed Quick Start Guide. You will need the code for the setup procedure after the lock is installed. The default Programming Code and two User Codes are printed on a sticker on the back of the printed Quick Start Guide. Find and record Programming and User Codes.Install the touchscreen on the outside of the door.If the measurement is 2C\v" (70 mm), extend the bolt.Ĭhoose the drawing that matches your door edge. Install strike and reinforcement plate into door jamb.ĭoor jamb may need preparation to fit strike reinforcement plate.Remove screw and remove spacer by rotating from the outside touchscreen. Only if crossbore is 1½" (Step A), Remove spacer.Make sure that the hole for the bolt in the door edge lines up with the hole for the strike in your door jamb. ![]() If crossbore is 1½", follow steps to remove spacer.Īlso, check your door alignment. See /Service-Support for door preparation instructions if dimensions are different. Install and test lock with door open to avoid being locked out.Use any QR code reader or type in the address into your web browser on any internet-connected device.ĭO NOT use a power drill for installation! Installation Instructions Check out the Interactive Instructionsįor step-by-step, illustrated and video instructions, check out the interactive instructions at the link below. Schlage Encode Smart WiFi Deadbolt BE489WB Manual
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |